Smartscan Incorporated
  • Home
  • Products
    • SG Series
    • T4Series
    • Pallet Safe
    • 8K3 Series
    • 1000 Seies
    • Non- Safety Light Grid
    • Safety Modules
    • Acessories
  • Applications
    • Manual Load and Unload
    • Robotic Applications
    • End of Line Packaging
    • Cold Room / Freezer Application
  • Product Support
  • Representation
  • Contact Us

Smartscan Safety Light Curtain T4B: Dipswitch Settings

The dip switches are located under the removable door on the end cap (near the cable connector) of the receiver column (labeled RX).
Picture
There are two modes of dip switch setting for the T4B light curtain system Direct Settings and Learned Settings. Below are descriptions of the direct and learned settings modes with a list of functions that can be applied in each setting.(Click on the highlighted text box of the mode or interest)
Picture
Picture
Direct settings are the functions that are available “out of the box”. No steps are needed to reach these functions. Place the dipswitches is the desired position then the functions desired are applied There are (4) four features available in the Direct Settings mode:
  1. Floating blanking
  2. Mute Dwell time
  3. Reset Modes
  4. Parity
Learned setting are functions that require multiply steps to be applied. This  mode allows the user to access the following functions:
  1. Fixed Beam
  2. Partial Muting
  3. Press mode
  4. Mute disparity /Mute delay OFF modes
  5. Clear (All Learned Functions)
The information and drawings contained herein are the sole property of Smartscan Incorporated. The informationon this website is subject to change without notice. Smartscan Incorporated shall not be liable for any errors contained herein for incidental or consequential damages in connection with the performance or use of this material.